[. . . ] - SCOPE Ø29 - K-LENS D C B Basic Unit: A A: 1 Scope-Body B: 1 ZEISS - K-Lens Ø29mm center-hole diam. [. . . ] Die Scope Pins sollten im Scope Pin Halter aufbewahrt werden und mit dem Scope Pin Tool ins Scope ein und vom Scope ausgebaut werden. White PLEASE NOTE: Scope Pins should be carried in the Scope Pin Holder and extracted from/installed in the Lens with the Scope Pin Tool!WEATHERSHIELD Colours: Black, Red, Light FLUORPINS Colours: Red, Green Orange, Blue, Black - for Hole-Ø1, 5mm/sightn1, 5mm MOUNTING ADVICE ATTENTION: The Scope must be fixed tight to the sight!Use following Beiter Spacers: - #8-32 (black) 2mm (a) and 5mm (b) - #10-32 (grey) 2mm (a) and 5mm (b) - O-Ring 4x2 for #8-32 (c) - O-Ring 5x2 for #10-32 (c) b c a LEVEL Ø10MM SYSTEM The Level Ø10mm system consists out of: 1 support with or without pin, 1 Holder for support and 1 level Ø10mm Colours: Black, Red, Green, Orange, Clear Mounting Advice: mount the desired sight insert on the support. Clip the level into the support and insert it (pins backwards) in the device of the scope body. Effect: the level will turn into the colour of the used support/holder combination! SHIELD for LEVEL Without Pin (d), with or without pin, Colours: Black, Red, Green, Orange, Clear MOUNTING ADVICE To install the shield, first push out the level, than insert the shield (pins backwards) in the device of the scope body. Reinstall and clip in the level. i d e g SIGHT INSERTS Rings and Square in following colours: Black, Red, Green, Orange Rings: 4mm (f), 6mm (i) or 9mm (g) Square: 6mm (j) or 9mm (h) Use the 4mm Ring only on the shield for level without pin! [. . . ] +49/7720/85680 Fax+49/7720/4238 www. wernerbeiter. com MADE IN GERMANY e-mail: info@wernerbeiter. com [. . . ]